torpedo depth

WidowMaker · 03-27-07, 12:50 PM

i recently asked this question on gamespot's sh4 forum to no avail yet, so i thought i'd ask a bigger community:

is it just me or is the recognition manual not accurate? i am setting torpedo depth to about 1 m below the stated ship draft in the manual but my torpedos end up being much lower than one meter and dont go off because they are out of influence range, anyone know why? its very annoying wasting torpedoes that wont go off because they are too low...

ive tried using both metric and imperial, in sh3 i could make the torps go off right under the ships because of the magnetic pin, now i can visually see them ending up a lot deeper than they are intended.

03-27-07, 12:50 PM	#1
WidowMaker Swabbie Join Date: Mar 2007 Location: Virginia Posts: 8 Downloads: 26 Uploads: 0	torpedo depth i recently asked this question on gamespot's sh4 forum to no avail yet, so i thought i'd ask a bigger community: is it just me or is the recognition manual not accurate? i am setting torpedo depth to about 1 m below the stated ship draft in the manual but my torpedos end up being much lower than one meter and dont go off because they are out of influence range, anyone know why? its very annoying wasting torpedoes that wont go off because they are too low... ive tried using both metric and imperial, in sh3 i could make the torps go off right under the ships because of the magnetic pin, now i can visually see them ending up a lot deeper than they are intended.