TDC -setting Gyro angle

Bilge_Rat · 10-31-13, 03:46 PM

I know there are many ways to setup firing solutions. My preferred route is to use the TDC, input all the data and let it come up with a firing solution.

One issue I keep encountering is that setting Gyro angles is not "sticky", so that, for example, if I set tubes 1-2-3-4 at -2, -1, 0 and +1, all tubes will be set at whatever Gyro angle I set for the last tube. This means that when I want to fire a spread, I have to manually set the angle on each tube before I fire.

Am I doing something wrong? Is there a workaround or a mod for this? I think I had asked the same question 1-2 years ago, but can't find the thread. I seem to recall the consensus was that it was a bug.

10-31-13, 03:46 PM	#1
Bilge_Rat Silent Hunter Join Date: Apr 2002 Location: standing watch... Posts: 3,855 Downloads: 344 Uploads: 0	TDC -setting Gyro angle I know there are many ways to setup firing solutions. My preferred route is to use the TDC, input all the data and let it come up with a firing solution. One issue I keep encountering is that setting Gyro angles is not "sticky", so that, for example, if I set tubes 1-2-3-4 at -2, -1, 0 and +1, all tubes will be set at whatever Gyro angle I set for the last tube. This means that when I want to fire a spread, I have to manually set the angle on each tube before I fire. Am I doing something wrong? Is there a workaround or a mod for this? I think I had asked the same question 1-2 years ago, but can't find the thread. I seem to recall the consensus was that it was a bug. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode