Olc Gui & Aob

BenG · 02-05-08, 04:26 PM

Bear with me on this one as I'm noyt sure of all the terms I have often used my own lexicon.

When I am trying to calulate the AOB in OLC I calculate the range as shown (counting marks). I then use this range to calculate the AOB by counting the horsontal marks. When I line the range up with the ship length - I often end up with the "ship width in marks" giving me an AOB greater than 90° - e.g. If the ship is 15 from "lock on point" to bow/stern (30 wide in total) 15 marks corresponds to a value on the AOB ring greater than 90° - am I doing something wrong?

On occasion I even back up the range calculation using the God's eye mode

02-05-08, 04:26 PM	#1
BenG Watch Join Date: May 2006 Posts: 30 Downloads: 4 Uploads: 0	Olc Gui & Aob Bear with me on this one as I'm noyt sure of all the terms I have often used my own lexicon. When I am trying to calulate the AOB in OLC I calculate the range as shown (counting marks). I then use this range to calculate the AOB by counting the horsontal marks. When I line the range up with the ship length - I often end up with the "ship width in marks" giving me an AOB greater than 90° - e.g. If the ship is 15 from "lock on point" to bow/stern (30 wide in total) 15 marks corresponds to a value on the AOB ring greater than 90° - am I doing something wrong? On occasion I even back up the range calculation using the God's eye mode __________________ -Ben Intel Dual Core @ 2.13 GHz (= 4.26 GHz (or so it is claimed!) 4 GB RAM (but due to 32-bit limitation I only get 3.074 GB) Windows Vista (a few compatability issues to begin with but works for me now)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode