Researching feasibility.

[Mork_417]

Hey guys, i am looking into doing a project with my SHIII, and if it works, i would love to use it for SH4 too. I've only been reading up on this for about a week now, and I am trying to figure out if it is possible to do the following...

Can these:

(Commands_en.cfg)

[Cmd334]
Name=Set_TDC_bearing
Ctxt=1
----------------------------------------------------------
(Dials.cfg)

[Dial11]
Name=Sol_Bearing
Type=24; DIAL_SOL_BEARING
Cmd=Set_TDC_bearing
Dial=0x3B0D00FF
CrtVal=0x3B0D0001
NewVal=0x0
DialVal=0,360
RealVal=0,360; degrees
Circular=Yes
CmdOnDrag=Yes
SndStep=5
SndList=1,Menu.TDC.Bearing,360

be adjusted so that instead of, or in addition too, the mouse being used to set the values, that i can use two keys to increment the value -1/+1 at a time?

Example: Key "<" = TDC_bearing -1 / Key ">" = TDC_bearing +1


When i was testing earlier today, I tried the following method...

[Cmd334]
Name=Set_TDC_bearing
Ctxt=1
Key0=0x59,s,"Y"

...and all it did was reset the dial/value to 0.


Any assistance or reference material you can point me to will be GREATLY appreciated. FYI, I have no code programming experience what so ever, and the only scripting knowledge i have is batch configuring networking devices, LOL.

Thanks in advance!