SH3 Inspector error

Wolf52 · 08-15-05, 04:45 PM

Every time i load the SH3 Inspector i get the following two error pop-ups before the SH3 Inspector starts:

NKGN unit bypassed
no .cfg file exists for this unit

NPTR unit bypassed
no .cfg file exists for this unit

The program seems to run fine though, what is this about? I should note that i have tried to use the new installer for the Merchant Variety Pack (with early and late skins included) but while backing up it could not find a few files, and after that (without running the program to randomize skins, have only backed up) i deleted the backups with the .bat file. Perhaps this has something to do with it?

timetraveller · 08-15-05, 05:01 PM

Hi Wolf52,

Check to see if these ships have config (.CFG) files in their folders. In my stock version of SH3, I don't even have an NKGN or NPTR ship. Ships are in your /Sea folder. The program is set up to ignore ships that don't have all the correct files in place.

Good luck.

TT

Wolf52 · 08-15-05, 05:11 PM

Both folders empty. Dunno why they are there...

08-15-05, 04:45 PM	#1
Wolf52 Torpedoman Join Date: Jun 2005 Posts: 115 Downloads: 3 Uploads: 0	SH3 Inspector error Every time i load the SH3 Inspector i get the following two error pop-ups before the SH3 Inspector starts: NKGN unit bypassed no .cfg file exists for this unit NPTR unit bypassed no .cfg file exists for this unit The program seems to run fine though, what is this about? I should note that i have tried to use the new installer for the Merchant Variety Pack (with early and late skins included) but while backing up it could not find a few files, and after that (without running the program to randomize skins, have only backed up) i deleted the backups with the .bat file. Perhaps this has something to do with it?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-15-05, 05:01 PM	#2
timetraveller Beach Leaf Join Date: Dec 2004 Location: Atlantic Shipping Lanes Posts: 287 Downloads: 1 Uploads: 0	Hi Wolf52, Check to see if these ships have config (.CFG) files in their folders. In my stock version of SH3, I don't even have an NKGN or NPTR ship. Ships are in your /Sea folder. The program is set up to ignore ships that don't have all the correct files in place. Good luck. TT

08-15-05, 05:11 PM	#3
Wolf52 Torpedoman Join Date: Jun 2005 Posts: 115 Downloads: 3 Uploads: 0	Both folders empty. Dunno why they are there...