Help with SH3 Commander & NYGM mod

[Sgt Swanson]

Hey guys,

When launching the game through SH3 Commander, I can get into the game just fine, but it locks up on the mission load up screen about half way through.

I'm currently using:

NYGM Tonnage Mod (kept having crew problems with Grey Wolves)
Improved Smoke v1.1
No Fatigue

The other problem I'm having is the crew will not reload the torps.

I had the game running great before loading Commander using the above mods. Now there's nothing but headaches!!

I need to know if there's a certian way to load the mods, and if so what is it for both GWT and NYGM.

Also, if there's any other mods that need to be included.

[melnibonian]

I think there were some issues with SH3 Commander and NYGM. Check the SH3 Commander FAQ or send an e-mail/PM to Jaesen Jones. I'm sure it was discussed before but I couldn't find the link. I'll have a look though again

http://www.users.on.net/~jscones/software/products.html

EDIT: Check out this thread. I think the NYGM issue is discussed there
http://www.subsim.com/radioroom/showthread.php?t=95448

[donlas]

I used to have the same problem, i found that if you go into the game via SH3 Commander but click on "start game for a single player mission" instead of for a career it would work, but that may of been just for me

[Sgt Swanson]

Well, Commander was set up for Career mode. Wouldn't do any good in Single Player mode.

And I have not found any documentation on this either on the forums or in any readme.txt.

[HW3]

There are files included in NYGM that have to be put in SH3 Commander for it to work right. They are in the documentation folder with instructions on what to do.

[Sgt Swanson]

Just read that. Going to give it a try.