Quote:
|
Originally Posted by Kojo62
Ahoy fellow Skippers. I was wondering if anyone could give me some tips on Mine detection and avoidance techniques?
I was on the stock mission in the Strait of Hormuz where you deploy one Seal team, then recover another, and negligently ran into a mine in between the two ops.  I didn't even know there were mines to be found in this strait, and I'd like to find out what I should've done to avoid this fate.
I read in the manual that High Frequency sonar is what should be used to locate mines. But isn't that an active sonar mode? Is there any way to employ this with passive? Pinging away in this region does not strike me as a good choice, given that my orders are to remain undetected. So I'm confused here.
 |
From the Sub Command manual...
Quote:
|
Originally Posted by Sub Command Manual pg.150
UUVs are in passive mode when launched. However, active sonar may be necessary when
traversing a minefield. Be aware that capable ships and subs in the area can detect UUV active
sonar.
Follow these steps to enable UUV active sonar.
1. Enable the wire guide controls for the UUV as described above.
2. Click ENABLE to initiate active sonar.
3. Click PRE-ENABLE to de-activate active sonar and return to passive mode.
|