SUBSIM Radio Room Forums - View Single Post

Wise · 07-26-16, 04:29 PM

Hmm... I understand.
I think, nothing will turn out.
In the file of the hull of the U-boat (Submarine/NSS_Uboatxx/NSS_Uboatxx.dat), in the main node there has to be a 3D model. In your new main node (Position) the 3D model is absent. Besides, 3d - center of model of the main node , is a water surface level point (waterline). Besides, dimensions of this model which are allocated above or below a waterline, also, have direct interrelation with a waterline. Possibly, they are "reference points" for the ACT and DLL files in which modeling of behavior of the boat on water is programmed (the surface position, emersion - immersion, draft, switching of engines from the diesel to electric motors and back, periscope depth, etc.)
In the Turms-files is allowed more free hierarchy of the nodes, because, Turms are children files from the hull . The main node of the Turm file is attached to a point of the node "Z01" of the hull, and not vice versa.
I regret, Manos.

07-26-16, 04:29 PM	#10
Wise Engineer Join Date: Jun 2012 Location: St.-Petersburg Posts: 217 Downloads: 5 Uploads: 0	Hmm... I understand. I think, nothing will turn out. In the file of the hull of the U-boat (Submarine/NSS_Uboatxx/NSS_Uboatxx.dat), in the main node there has to be a 3D model. In your new main node (Position) the 3D model is absent. Besides, 3d - center of model of the main node , is a water surface level point (waterline). Besides, dimensions of this model which are allocated above or below a waterline, also, have direct interrelation with a waterline. Possibly, they are "reference points" for the ACT and DLL files in which modeling of behavior of the boat on water is programmed (the surface position, emersion - immersion, draft, switching of engines from the diesel to electric motors and back, periscope depth, etc.) In the Turms-files is allowed more free hierarchy of the nodes, because, Turms are children files from the hull . The main node of the Turm file is attached to a point of the node "Z01" of the hull, and not vice versa. I regret, Manos. Last edited by Wise; 07-26-16 at 10:56 PM.