Down Periscop Down i say !!!!

[NKVD-crazyivan]

:damn: HI all i have a Periscop problem.
I just upgraded my coning tower on my type 1X-C/40 to the 2x light flak and 1x 37mm flak.........i also ran into the same thing when i had my 1X-C with the same fitout.
Both my attack peri and observation peri wont go all the way down into ther protective housings..I know they never have gone completly down just showing above by about 6-8 inchs but know they are a good 3-4 feet out,so when you turn around on the bridge you get a face full of periscop.....my men are complianing that they are constantly being watched.

is this a bug or normal it seams so far just in this type of coning tower...

they are about dead leval with the top of the bridge maybe just a little lower.when you look at the scop you cant see anything it goes down when you operate the controls ok as if its in the protective housing..........but it just sits up way to high for my liking..

is there a fix i run SH3 commander and GW i dont want to screw up any of this....


thanks in advance for any help;)

[panthercules]

There is a fix for this, at least for the scopes on the Type IXB (the one I used it on in my current career) and I think they did it for the other types as well. The NYGM team came up with it, but it seems to work without the rest of the NYGM super mod package (I'm still running on my old GW 1.0 install since I'm too lazy/busy to make all my personalizations again until one of the big supermods gets all of Anvart's lighted ships included in it).

I think this is the link for the thread about the fix:

http://www.subsim.com/radioroom/showthread.php?t=94873

Good luck!