Failing to apply SCXII

[wong tat]

hello
i'm crying for help:
i've installed & applied SCXIIc but it couldn't be started the game any more
i.e. once it is started SubCommand, it shut down at once...
could anybody explain why & the entire installing procedures...?
thanks a lot
wong tat

[Ultraboy]

There are a couple of .bat files you have to run before SCXIIc will work, in case you haven't already done so...

1) Go to your Sub Command\Graphics folder, there is a file called Install_Graphics.bat. Run it, it usually takes a while so be patient.

2) Go to your Sub Command\Interfaces\AkulaII folder, there is a file called Install_Loadout.bat. Run it as well.

These are the two steps I missed the first time I installed SCX, and I was having the same problem. Hope this helps!

[Bellman]

Yeh as Ultraboy said - just right for SCX and if you go on to SCX2 you have to run another Install_Graphics.bat.

Might help to rename the SCX one post install (I think you can remove it ) - that ensures that subsequently
you dont rerun the old one rather than the later addition.

Happened to me. :down:

[Bellman]

Wong - did you get up and running ok ?