Polak2
07-05-17, 04:35 PM
Thanks to Wildcat I successfully managed to install 3dSMax 3.1 and made some trial exports of some 3d to j3d format. All basically works, however there is limit of model complexity in j3d theoretically maxing up to 32768 vertices.
This would be not end of the world , however in practice this limit appears to be quite lower. I have a difficulty to export anything above 10K verts and this is little to low for visible and possibly improved results. At the same time, I see, that some of the models recently introduced to RA DWX (like Kara) has over 20K vertices so there must be a way.
Anyone kind enough possibly to shed some light on this problem?
PS. Thanks to Wildcat again for finding elusive and hard to get max 3.1
This would be not end of the world , however in practice this limit appears to be quite lower. I have a difficulty to export anything above 10K verts and this is little to low for visible and possibly improved results. At the same time, I see, that some of the models recently introduced to RA DWX (like Kara) has over 20K vertices so there must be a way.
Anyone kind enough possibly to shed some light on this problem?
PS. Thanks to Wildcat again for finding elusive and hard to get max 3.1