problems with event camera and real ships names

[lobomarinho]

Hy Grey Wolves!!

I have updated my SH3 GWX 2.1 to 3.0 as well as the latest SH3 Cmdr 3.2 and JSGME.
I have two problems in this fantastic mod:

1) After sinking 1 or 2 ships my event camera ,the one activated by pressing "," goes nuts = I can no longer see the uboat from outside or any of my sonar contacts; the picture oscilates under and above water from a very far away spot. The only camera that works is the one used by pressing the "eye"button on the left panel.

2) Even if I enabled the real ship snames in SH3Cmdr I do not get any ship names in my patrol logs. I have checked that I have a cfg file with 211 Kb on SH3 Cmdr ( I could not open the fiel to see the contents of the folder).

Has someone experienced these problems and/or have found a solution???

Otherwise I must say that this Mod is fantastic.

I have benn playing Grey Wolfes in the past 2 years but GWX 3.0 is the best so farwith the exception for these 2 problems.

Many thansk for any help.
Lobo Marinho

[HW3]

The ship names do not show up until the patrol is finished, and only show in the SH3 Commander patrol report.

[lobomarinho]

The ship names do not show up until the patrol is finished, and only show in the SH3 Commander patrol report.
Thanks for your reply! I was aware of this specific note when I read Jimbuna's lead on this subject.

I have heard that the event camera problem that I am experienced has been detected by other users, it is an intermitent problem and apparently it has not been solved yet.

Do you have experienced the same problem???

Best regards,
Lobo marinho