Log in

View Full Version : Instillation instructions would be nice

STEED
12-11-07, 02:44 PM
After reading some posts I see some of the lucky few are running in to problems with GWX 2.0, would be nice if you GWX guys put up a post what we should all do.

By the way, info on Silent Hunter Commander would be nice as well.

This may cut down on some of the many questions that will wing there way to you.
danlisa
12-11-07, 02:48 PM
Actually I'm looking to add full instructions to the GWX homepage tonight.

We'll cover:
Uninstalling SH3 fully.
Use of the MD5 Mate.
Installation of GWX.
Installation of GWX v2.0's cfg files for SH3Cdmr.

However, I should add, all the instructions you need for installing GWX are in the manual.

I just have to take care of a small problem.;)
JU_88
12-11-07, 02:51 PM
Looks liek you beat me to it Dan :oops:
STEED
12-11-07, 02:57 PM
Actually I'm looking to add full instructions to the GWX homepage tonight.

We'll cover:
Uninstalling SH3 fully.
Use of the MD5 Mate.
Installation of GWX.
Installation of GWX v2.0's cfg files for SH3Cdmr.

However, I should add, all the instructions you need for installing GWX are in the manual.

I just have to take care of a small problem.;)

Good Show that man. :up:
Penelope_Grey
12-11-07, 03:39 PM
Might I recommend the manual too? :D
NealT
12-11-07, 03:52 PM
I like the idea of 'instillation instructions'. However, the ATF shut down my still some time ago...:yep: [must have been some fumble-fingers getting in the way]

From what I have read in the manual...the only thing that I could not find was 'what to do with the SHCommander' files and that one I think I can figure out without too much trouble. The rest of it looks to be a piece of cake...:up:
3Jane
12-11-07, 03:56 PM
I just copy/pasted them. Haven't had time to try it yet, so I don't know if that is the right way or if it works. Couldn't find anything about those files except that they were needed.
bigboywooly
12-11-07, 04:44 PM
The SH3commander files go into C:\Program Files\SH3 Commander\Cfg
3Jane
12-11-07, 04:58 PM
[quote=bigboywooly]The SH3commander files go into C:\Program Files\SH3 Commander\Cfg[/quote

Ah, good. That's where I put them.
Jimbuna
12-11-07, 05:19 PM
Hey!!......STEED!!
http://img129.imageshack.us/img129/2725/rtfmrb3.jpg (http://imageshack.us)

http://www.abfnet.com/forum/images/smilies/goofy2.gif
danlisa
12-12-07, 05:06 PM
It's not anything new and it's all in the manual but the website has been updated.:up:

See under my sig.