SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > General > General Topics > PC Hardware/Software forum
Forget password? Reset here

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-24-08, 12:16 PM   #1
alexcraig
Swabbie
 
Join Date: Mar 2008
Posts: 10
Downloads: 0
Uploads: 0
Default After Upgrade 3D Stops and Restarts

Greetings folks,

Have scoured this forum for an answer to this issue without luck.

I have SH4 installed with all patches.

Ran fine until I recently upgraded from an Extreme P4 Pressler to an extreme Quad QX6800. I also upgraded from a 4850 to an ASUS 4870 Top. I suspect the problem somehow involved the ATI settings for the new graphics card.

Anyway, the game loads OK. However, as soon as I get into the sub (into 3D) after a few seconds the game freezes for 2 to 6 seconds and then starts again. It repeated does this. I.E. Runs for 5 seconds or so and then freezes for 5 seconds or so.

FYI, the temps on my grphics card are fine at around 55 deg C.

Should I uninstall/reinstall the game? Or, are there one or more ATI settings for .cfg settings I can tweak?

Any help would be appreciated.

Thanks in advance

Regards,

Alex Craig

MSI 975X Platinum 'Power Up' Edition
Intel Core 2 Extreme Edition QX6800 1066MHz FSB 2 x 4MB L2 Cache
2 Gig of 'Extreme Dominator' DDR2 RAM
ASUS R4870 Top Video Card
Antec 850 TRUEPOWER Quattro PSU
Realtek HD Audio
alexcraig is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:34 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1995- 2024 Subsim®
"Subsim" is a registered trademark, all rights reserved.