How I solved my menuid errors

supposedtobeworking · 07-31-06, 05:31 PM

I've been having these until recently so here is how i fixed it for those who might benefit--

write down the menuid # when the error pops up --
search on that number in the menu1024.ini file or dials.cfg
see what it refers to, i.,e. periscope stuff or tdc layout, etc. then search on that to see if you find anything suspicious. usually the menu numbers are duplicated or out of order:

Mine turned out to be a double numbering of G3F I140 -- so I had to renumber everything after G3F I140. I was using:

GW 1.1a
SH3 Comm 2.6
TDC Slideout for attack scope
4Dials slideout

now everything runs flawlessly. no errors

Von Hinten · 08-02-06, 10:20 AM

I'm keeping this handy for when I'm getting them again. It's been a while now but you never know. Thanks for sorting this m8.

07-31-06, 05:31 PM	#1
supposedtobeworking XO Join Date: Jul 2002 Posts: 436 Downloads: 59 Uploads: 0	How I solved my menuid errors I've been having these until recently so here is how i fixed it for those who might benefit-- write down the menuid # when the error pops up -- search on that number in the menu1024.ini file or dials.cfg see what it refers to, i.,e. periscope stuff or tdc layout, etc. then search on that to see if you find anything suspicious. usually the menu numbers are duplicated or out of order: Mine turned out to be a double numbering of G3F I140 -- so I had to renumber everything after G3F I140. I was using: GW 1.1a SH3 Comm 2.6 TDC Slideout for attack scope 4Dials slideout now everything runs flawlessly. no errors

08-02-06, 10:20 AM	#2
Von Hinten Commander Join Date: Mar 2006 Location: Netherlands Posts: 466 Downloads: 54 Uploads: 0	I'm keeping this handy for when I'm getting them again. It's been a while now but you never know. Thanks for sorting this m8. __________________ Regardz, Von Hinten UC3 Nautilus' engineer for 45 minutes!