SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Wolfpack: the new multiplayer co-op U-boat simulation > Wolfpack
Forget password? Reset here

Reply
 
Thread Tools Display Modes
Old 05-18-2021, 02:30 AM   #1
VonHoffman
Watch
 
Join Date: Oct 2019
Location: Near crush depth. Maybe.
Posts: 20
Downloads: 6
Uploads: 0
Default Dive Planes and Optimum Normal Dive

Something I've been experimenting with for a while now is how to dive the boat promptly without performing a crash dive.

Maybe there is something I'm not understanding completely, but let me start with how the boat is configured:

* It is broadly set up for neutral bouyancy with the MBT flooded. It will hold depth at zero angle and a level boat.

To commence a dive (single crew), I do the following:

* Set engines to electric and ahead half
* Dive planes down 20 dgrees both fore and aft
* Flood the MBT (fore first to get the nose down)

The boat seems to stick on the surface a bit longer than anticipated, given the dynamic pitching of the boat.

It seems that not until both MBT are flooded will the boat actually start to dive.

Am I just being impatient? :P

Thanks in advance.
VonHoffman is offline   Reply With Quote
Old 06-09-2021, 11:17 AM   #2
Hoagie27
Nub
 
Join Date: May 2021
Location: below the surface
Posts: 4
Downloads: 1
Uploads: 0
Default

I've been playing around with the tanks and I've gotten to the point that I can dive the ship in about 35secs. Here's how i do it.

Basically you want to keep some water in the ballast tanks while cruising on the surface. Anything more than a total of 35m^3 between the 2 main ballast tanks will cause you to lose significant speed(a loss of more than 1kn)

I keep 10m^3 in the rear main ballast tank and 25m^3 in the front main ballast tank. Keep your dive plans at 0. This will keep the ship level while the tanks are primed

If you need to dive to periscope depth;
-Switch to electric engines(Half ahead)If you don't do this first there is a very good chance you'll flood the diesels,
-Open and flood both the front and rear tanks
-Make for a full flat dive(front planes all the way down and the rear plans all the way up)
-Once you reach a depth of 10.5m, bring both of the dive planes back to 0. By the time they reach 0 you'll be at or near a depth of 12m and neutrally buoyant. Adjust your depth as needed by using the dive planes.

If you need to dive deeper than 20m, follow the above steps but set your rear dive plans to -30 and flood the neg tank.
Hoagie27 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:32 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright © 1995- 2021 Subsim®
"Subsim" is a registered trademark, all rights reserved.