how to make your gui compatible with Flakmonkey & DD's mod

comet61 · 03-01-10, 04:29 PM

Makman-

I have done the editing on both files and made a separate folder to load into JGSME, however, I just realized that I need the OLC fix that came with the FM mod. So, via JGSME I load the FM mod, then the OLC fix then the new edited files last...so this ought to work per your instructions? Am I understanding that correctly? Thanks in advance.

UPDATE: OK...the edits all work except 2 things (minor perhaps): I have no volume control on the hydrophones and the shift-e key to the engine room does not work. See below. Earlier, before the edits, the hydrophones were off by 20°, now they are good. The new animations and click spots are working OK. I'm pretty sure the hydro volume is controlled in the sound files? On another note, using OLC fix with the new Camera.dat edits, both scopes, binoculars and UZO all work fine. Crosshairs are aligned, magnification settings are good too.

I copied and pasted the Cmd line from the FM mod cfg file to the edited one I made per Makmans instructions. It works now. This will enable you to go to the engine room by pressing shift+e.
[Cmd11]
Name=Interior_aft_camera
Ctxt=1
Key0=0x45,Cs,"Shift+E"
Page=0x33000000,3704
GoBack=Interior_fore_camera

03-01-10, 04:29 PM	#5
comet61 Sparky Join Date: Oct 2009 Posts: 151 Downloads: 240 Uploads: 0	conversions Makman- I have done the editing on both files and made a separate folder to load into JGSME, however, I just realized that I need the OLC fix that came with the FM mod. So, via JGSME I load the FM mod, then the OLC fix then the new edited files last...so this ought to work per your instructions? Am I understanding that correctly? Thanks in advance. UPDATE: OK...the edits all work except 2 things (minor perhaps): I have no volume control on the hydrophones and the shift-e key to the engine room does not work. See below. Earlier, before the edits, the hydrophones were off by 20°, now they are good. The new animations and click spots are working OK. I'm pretty sure the hydro volume is controlled in the sound files? On another note, using OLC fix with the new Camera.dat edits, both scopes, binoculars and UZO all work fine. Crosshairs are aligned, magnification settings are good too. I copied and pasted the Cmd line from the FM mod cfg file to the edited one I made per Makmans instructions. It works now. This will enable you to go to the engine room by pressing shift+e. [Cmd11] Name=Interior_aft_camera Ctxt=1 Key0=0x45,Cs,"Shift+E" Page=0x33000000,3704 GoBack=Interior_fore_camera Last edited by comet61; 03-01-10 at 04:55 PM.