A simple question on bearing

Pisces · 05-27-08, 05:41 AM

Yes and no! As Bert8for3 says, the bearing dial (or scope viewing direction) drives the needle on the gyro angle dial after the lead-aim is calculated based on the other 3 dials (range, AOB, target and torpedo speed). But since you want 0 gyro angle for best aiming accuracy (when torpedo's do not need to turn) you still look to the gyro dial to see at which bearing you should fire. And so I allways wait for the target to pass that bearing (which results in 0 gyro angle) through the scope or on hydrophone before I pull the trigger.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-27-08, 05:41 AM	#1
Pisces Silent Hunter Join Date: Dec 2004 Location: AN9771 Posts: 4,904 Downloads: 304 Uploads: 0	Yes and no! As Bert8for3 says, the bearing dial (or scope viewing direction) drives the needle on the gyro angle dial after the lead-aim is calculated based on the other 3 dials (range, AOB, target and torpedo speed). But since you want 0 gyro angle for best aiming accuracy (when torpedo's do not need to turn) you still look to the gyro dial to see at which bearing you should fire. And so I allways wait for the target to pass that bearing (which results in 0 gyro angle) through the scope or on hydrophone before I pull the trigger.