SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
|
|
Thread Tools | Display Modes |
|
08-30-18, 04:35 PM | #1 |
Seaman
Join Date: Jul 2018
Location: Florida
Posts: 31
Downloads: 1
Uploads: 0
|
Unable to dock at Brisbane or Pearl Harbor
Following my last career mission I was given a new boat and assigned to Brisbane. I completed the mission objective, to patrol off the Marshall Islands. Then sank 18,000 tons, was low on fuel, and had 2 torpedoes remained fore and aft. On returning to Brisbane the only choice was to refit, which I did. Then went back out on patrol again and sank another 7,000 tons. On returning to Brisbane I could still only refit. This time I motored to Pearl Harbor, thinking maybe I had to return to my original base in order to dock, but still could only refit. This is becoming an endless patrol.
Anybody know how to end this mission and still keep on the career track?
__________________
Now where did I put that clock key? |
08-30-18, 05:12 PM | #2 |
Run silent, run deep
Join Date: Jun 2016
Posts: 225
Downloads: 59
Uploads: 0
|
I recall that happening a while back... IIRC, I saved the game and reloaded it and the correct base showed up on the reload.
|
08-30-18, 05:16 PM | #3 |
CTD - it's not just a job
|
For whatever reason, some of the boats that transfer to Brisbane, get sent to Fremantle the very next time out (crybaby Christie??), so look for the slanted anchor that signifies "Home", and it might be over on the Western Australia side of things, and not Wellington...
|
08-31-18, 05:39 AM | #4 | |
Sonar Guy
Join Date: Feb 2013
Location: Sarasota Florida
Posts: 391
Downloads: 68
Uploads: 0
|
Quote:
|
|
08-31-18, 09:20 AM | #5 | |
Ace of the Deep
Join Date: Feb 2004
Location: Colorado
Posts: 1,062
Downloads: 397
Uploads: 0
|
Quote:
Hint: Always check for the location of the tilted anchor before heading back to "base".
__________________
Run Silent, Run Deep, and Sink 'em All |
|
08-31-18, 09:55 AM | #6 |
Sonar Guy
Join Date: Feb 2013
Location: Sarasota Florida
Posts: 391
Downloads: 68
Uploads: 0
|
[QUOTE=hint: Always check for the location of the tilted anchor before heading back to "base".[/QUOTE]
So true! After that patrol, I always check. |
08-31-18, 12:05 PM | #7 | |
Run silent, run deep
Join Date: Jun 2016
Posts: 225
Downloads: 59
Uploads: 0
|
Quote:
AMEN!! Nothing quite like starting back after a very successful patrol and getting halfway to a base that no longer exists without enough diesel to make it to a refit facility... Found out that CINCPAC sent the "base change" in a radio message I must have missed in the heat of battle... |
|
08-31-18, 01:30 PM | #8 | |
CTD - it's not just a job
|
Quote:
|
|
Thread Tools | |
Display Modes | |
|
|