SUBSIM Radio Room Forums - View Single Post

MarkShot · 02-03-08, 10:32 PM

Aaron,

I have attempted a few intercepts without too much success. I have identified the following causes:

Problems:

(1) Inaccurate data collected.

(2) Early radar sets with limited range.

(3) On fast contacts with low powered radar a lot of time is lost laying to while working out a plot. If it was initially in motion on a rough vector, the chances of an intercept could be greatly increased.

How would I attempt to do a running intercept where I do not lay to for 15-30 minutes to gather two tuples of data? Thanks.

02-03-08, 10:32 PM	#3
MarkShot Ace of the Deep Join Date: Jul 2002 Posts: 1,134 Downloads: 93 Uploads: 0	Aaron, I have attempted a few intercepts without too much success. I have identified the following causes: Problems: (1) Inaccurate data collected. (2) Early radar sets with limited range. (3) On fast contacts with low powered radar a lot of time is lost laying to while working out a plot. If it was initially in motion on a rough vector, the chances of an intercept could be greatly increased. How would I attempt to do a running intercept where I do not lay to for 15-30 minutes to gather two tuples of data? Thanks. __________________ War games, not wars! --- Only a small few profit from war (that should not stand)!