SUBSIM Radio Room Forums - View Single Post - DCS Kamov Ka-50 Black Shark Procedures

Arclight · 05-26-10, 06:32 AM

Checklist is good, but all the panning around between the panels is confusing. To simplify, you can go front, right, rear;

Turn on batteries and/or ground power. First basic step.

Front:
(left) K-041
(right) Abris

Right:
Comms (all radio switches except last one)
Fuel gage
Fire suppression
Standby SAI

Rear:
INU power and heat
Ekran self test

Then back to front to push the blinking light, and continue with APU/engine start.

* and something missing is closing the APU valve after shutting it down and powering NAV system (both wall panel).

05-26-10, 06:32 AM	#4
Arclight Navy Seal Join Date: Jun 2008 Location: Land of windmills, tulips, wooden shoes and cheese. Lots of cheese. Posts: 8,467 Downloads: 53 Uploads: 10	Checklist is good, but all the panning around between the panels is confusing. To simplify, you can go front, right, rear; Turn on batteries and/or ground power. First basic step. Front: (left) K-041 (right) Abris Right: Comms (all radio switches except last one) Fuel gage Fire suppression Standby SAI Rear: INU power and heat Ekran self test Then back to front to push the blinking light, and continue with APU/engine start. * and something missing is closing the APU valve after shutting it down and powering NAV system (both wall panel). __________________ Contritium praecedit superbia.