I think I will do it a bit different when it comes to washing the parts with water and soap.
First I will see in the manual which part is needed to make this section of the model-These will be cut off from the tree.
Then I'll take a cup add some almost slightly warm water and a few drops of dishwashing liquid. In there I will put these parts and let it be for an hour.
Thereby there's no chance for smaller parts to disappear-down the drain.
The bigger parts will be placed on a smaller towel or tea towel and using this towel to gently remove/dry the parts
The smaller parts will be dried by using a clean dry paint brush
(Brushing the small waterboble of the small part)
This is what I have been thinking on how I will proceed with this interesting thing in washing the parts with water and soap/dishwashing liquid.
Edit
Bigger parts will be put in a little bowl I have.
End edit
Markus
Last edited by mapuc; 09-29-20 at 05:17 PM.
|