SUBSIM Radio Room Forums - View Single Post - Problems with SH3 Commander? Check here first!

vois2 · 01-22-06, 05:12 PM

I use SH3 Commander v2.4 .

Before asking this question, I used the FAQ at the iinet.au site, as well as Googled +invalid +argument +to +date +code with a restriction of subsim.com domain. It seems this question was asked once before, but JScones reply to the problem was contained in a private message to the person experiencing the error.

When I load up SH3 Commander v2.4, in the 'Existing Careers' side panel, there are a number of careers that when clicking on them I receive only the "Invalid argument to date code" error. How does one remove these careers from that list? Thank you.

01-22-06, 05:12 PM	#51
vois2 Engineer Join Date: Apr 2005 Location: Southwestern Ohio Posts: 213 Downloads: 0 Uploads: 0	error: "Invalid argument to date code" I use SH3 Commander v2.4 . Before asking this question, I used the FAQ at the iinet.au site, as well as Googled +invalid +argument +to +date +code with a restriction of subsim.com domain. It seems this question was asked once before, but JScones reply to the problem was contained in a private message to the person experiencing the error. When I load up SH3 Commander v2.4, in the 'Existing Careers' side panel, there are a number of careers that when clicking on them I receive only the "Invalid argument to date code" error. How does one remove these careers from that list? Thank you. __________________ I donate to Subsim because it is one of the best communities on the Interwebs. Stick around a couple of years, and you will see. You're never far from a friend here. Sunk at location vois22 [at] gmail . com