View Single Post
Old 06-12-20, 02:19 AM   #1
Krellian
Swabbie
 
Join Date: Jun 2020
Posts: 10
Downloads: 4
Uploads: 0
Default AOB Calculation from Mast

Hi there, just thought I'd propose a way to calculate AOB. This only assumes the mast is straight up and down. I'm not sure if I have the calculation right where 1 degree on the protractors = 10 degrees of AOB. Might need a function in place of a ratio, or some adjustment for the center mast angle. Also, some masts are a bit crooked or wider at the bottom, so sometimes you have to figure out where the middle of the mast is when using your protractor - either using the average middle looking spot, or smoothing out the middle as a trendline to find the right spot.


(Maybe even I should just hang a plumb-bob from the protractor instead of using the mast angle)




However, I noticed all the masts are pretty much an x on a stick with even sides so figured I'd try to calculate AOB on them. I used an example from https://www.subsim.com/tips/wolfpack/aob.htm





Krellian is offline   Reply With Quote