SUBSIM Radio Room Forums - View Single Post - Need some training for U-Boat add on

Sub Sailor · 11-25-08, 07:16 PM

I unloaded everything and started from scratch;
1. Loaded SH4 Checked and it was fine
2. Patched SH4 with 1.4, checked and that is what splash screen says I had
3. Loaded U-Boat Mission mod, checked it and I have it and it works splash screen indicates 1.5.
So now I should load TMO v152.7z correct? You asked about if I was using JGSME, no I am using winRandR as that is what is called for.
I am sure that is what I did before, is there a setup step after I have installed TMO 152.7z? I no that there was 2 folders Data and Support. So am I missing a step? If I can get this going again I will try your mod. I did check the setup after each install using the sub school scenarios and they worked fine. I AM HOLDING OFF INSTALLING 152.7z UNTIL I HEAR FROM YOU. I can't express how much I appreciate your efforts.

Thank you,

Ron Banks MMCM(SS), USN(Ret)

11-25-08, 07:16 PM	#6
Sub Sailor Commander Join Date: Sep 1999 Location: Orofino, Idaho Posts: 443 Downloads: 66 Uploads: 0	OK here is where I stand azt the moment. I unloaded everything and started from scratch; 1. Loaded SH4 Checked and it was fine 2. Patched SH4 with 1.4, checked and that is what splash screen says I had 3. Loaded U-Boat Mission mod, checked it and I have it and it works splash screen indicates 1.5. So now I should load TMO v152.7z correct? You asked about if I was using JGSME, no I am using winRandR as that is what is called for. I am sure that is what I did before, is there a setup step after I have installed TMO 152.7z? I no that there was 2 folders Data and Support. So am I missing a step? If I can get this going again I will try your mod. I did check the setup after each install using the sub school scenarios and they worked fine. I AM HOLDING OFF INSTALLING 152.7z UNTIL I HEAR FROM YOU. I can't express how much I appreciate your efforts. Thank you, Ron Banks MMCM(SS), USN(Ret)