Quote:
|
Originally Posted by sergbuto
Quote:
|
Originally Posted by ZeeWolf
Quote:
|
Originally Posted by Orion2012
Would you care to go into more detail on what was done to resolve the issue??
|
I was waiting to see if there was any interest, being always busy
with something.
To make the solution basic, I separated close opposing faces. That
had the most immediate results.
Do you use any 3d software?
-ZeeWolf |
Yes, this is important because 3D models need to be scaled down by 10 from their real sizes before importing them to SH4 which may create such a problem. |
That is true but also mention the fact that once properly
sized you need to do a negative one scale (-1) on the
X axis to both flip the faces and mirror the prototype.
And do this process on newly created models only.
-ZeeWolf