What I mean is I always forget set TDC auto update on after manual input parameters in periscope TDC interface, and you know what will happen next when I launch the torpedo - the TDC target bearing is not equal to Periscope bearing while fireing.
It seems no way to indicate the TDC auto update on or off in periscope interface. Try to move the auto update switch or the device glass (can change bright by on or off) to periscope failed. So I try to show the TDC target bearing with the Periscope bearing side by side so I can know they are point to same direction or not. But this attempt also failed.
Just tested use original style TDC target bearing display in periscope interface. But after I am too busying to set the paramters, I can not notice it and so it can not prevent me make mistake
