SUBSIM Radio Room Forums - View Single Post - No clicking when turning periscope- pls help

Ducimus · 06-18-08, 10:22 PM

It's the "SndStep=5" line if i recall correctly. If not that line by itself, its both of these:

SndStep=5
SndList=1,Menu.TDC.Bearing,360

I recall remarking those out in the dials.cfg. The sndstep, im pretty sure means "make a click in 5 degree increments" since the orginal bearing indicator was in 5 dgree increments. Set that to 1, and im pretty sure you'll have a whole lot of clicking going on.

06-18-08, 10:22 PM	#5
Ducimus Rear Admiral Join Date: May 2005 Posts: 12,987 Downloads: 67 Uploads: 2	It's the "SndStep=5" line if i recall correctly. If not that line by itself, its both of these: SndStep=5 SndList=1,Menu.TDC.Bearing,360 I recall remarking those out in the dials.cfg. The sndstep, im pretty sure means "make a click in 5 degree increments" since the orginal bearing indicator was in 5 dgree increments. Set that to 1, and im pretty sure you'll have a whole lot of clicking going on.