[rowi58]

Originally Posted by Reece

Previously I thought this to be a fault of the zones.cfg file but this has been fixed and on a completely new patrol & area came across this, engines running but stationary:

I was able to sink it but even after "NA she's going down" message the man is still there:

The Schute_M2.cfg file contains the following:

[Unit]
ClassName=Schute_M2
UnitType=104
MaxSpeed=9
Length=48
Width=9.8
Mast=11.3
Draft=2.2
Displacement=305
RenownAwarded=20

[2DCompartments]
UnitPos=137,12,237,16
NbOfComp=1
Name1=Keel
Area1=203,5,93,11

Is there any problem, seems the ships waterline is way too high, any suggestions?
I tried to load the Museum but gets to about 1/4 way with red bar & CTD, all mods have been disabled, I did forget to roll back SH3 Commander, doubt this would cause problems!
Any ideas?
Thanks.

Hi Reece,

you can fix the problem (of draft) in the SIM-file. Open the SIM-file (with MiniTweaker or S3D), go to "obj_hydro" - "surfaced" - "draught" and set "draught=2,2". This will keep the small tender on his CWL.

Greets
rowi58