I was just about to post another message when I saw your recent post. In the course of trying this out, I discovered, I think, that you need to set the range to something in order for it to work, so I set it at 1500. First, of course, you set the target speed. Then set aob 90 left or right depending on the setup. Then set range to 1500. THEN, pick a target. Aim the scope where you want to hit, click the send bearing button and shoot. Move the scope a few degrees to the next spot on the target and shoot agian. Pick another target. Aim at a spot on the target, click the range button and shoot. Pick another spot on the target and shoot again. (too bad the game doesnt automatically select the next tube) so far, in my limited testing, you need to click the send range button for each target but not each shot. I havent tried it in an ideal setup, with two or three targets between 350 and 20 degrees and under 2500 yds but so far in the Borneo mission I have been getting hits on multiple targets, not 100%, but definately worth pursuing. Thanks! JOe S
|