SUBSIM Radio Room Forums - View Single Post

panthercules · 10-09-07, 11:48 PM

OK - minor problem here - I don't seem to have a tweak file for this sensor file for the minitweaker, so I tried using S3D, but there are so many nodes/things displayed in there that I can't figure out which one is the one I need to be messing with to make this change to the right hydrophone ball sensor. Any clue as to which node/location this is in S3D terms? (I'm guessing it's either 47, 49 or 53, with 49 being my leading candidate, but I'm really just guessing here based on it looking like it was the middle one of three hydrophone entries and these are the only three where the sensor is type 3 as well - plus 49 is the only one of these three where the maxsensorheight was zero, as seems to be indicated in the earlier thread )

10-09-07, 11:48 PM	#14
panthercules The Old Man Join Date: Apr 2005 Posts: 1,336 Downloads: 6 Uploads: 0	OK - minor problem here - I don't seem to have a tweak file for this sensor file for the minitweaker, so I tried using S3D, but there are so many nodes/things displayed in there that I can't figure out which one is the one I need to be messing with to make this change to the right hydrophone ball sensor. Any clue as to which node/location this is in S3D terms? (I'm guessing it's either 47, 49 or 53, with 49 being my leading candidate, but I'm really just guessing here based on it looking like it was the middle one of three hydrophone entries and these are the only three where the sensor is type 3 as well - plus 49 is the only one of these three where the maxsensorheight was zero, as seems to be indicated in the earlier thread ) __________________ Last edited by panthercules; 10-10-07 at 12:00 AM.