Right now I've done some control tests to start. Single large merchant amd a SC in a line. I approach from the front quarter. I tested stock, and the stock sensors DAT combined with the 2 cfg files from TM1.6. All at 8 knots.
In both control cases, the detection is VERY sensitive to aspect ratio. If I keep my nose at the SC, I can get inside 500 yards before I get a reaction. I can steam parallel at 1nm with no problem in either., too. With the TM cfgs, I get detected showing more than the bow at 0.7nm. I haven't even tried the altered dat yet since I got so damn close in both stock and TM values.
I think I need to make a bigger convoy so I can't control what I present to the target so easily, this is very hard to test.
tater
|