Quote:
|
Originally Posted by 558800
Quote:
|
Originally Posted by amurph182
After you take two range measurements and click the estimate speed button, you get something like "target speed 5 knots, course 285". You then send that to the tdc and adjust the AOB accordingly.
|
But,before you get "target speed 5 knots, course 285" ,you have to take two range measurements and two aob measurements . So that two aob measurements how to get? |
no. you ONLY have to take range. Take range, send to tdc. Wait a few minutes. Take another range, send to tdc. Click on the speed estimate tool and click the button to estimate speed. It will tell you the course and speed. You do NOT need to get AOB or ANYTHING other that range (which also gets bearing) in order to have the course and speed estimate.
This is how it works with patch 1.3. There's a sticky on it right at the top of the first page of this forum.