SUBSIM Radio Room Forums - View Single Post

Canonicus · 06-17-07, 12:26 PM

Thanks for the nice words, Mraah..... I try to help, if I can.

As far as making the camera fixed on the radar screen and not move....
Here's the particulars for that mod....
------------------------------------------------------------------------

Open Camera_dat via MiniTweeker and go to RadioRoom_Radar_Ascope

Look for AxisRotation Angles Min / Max

You'll see TWO sets... The upper set are the values controlling range, in degrees, for vertical motion.
The lower set are the values controlling range, in degrees, for horizontal motion.

We're going to adjust those values.

Change the upper set to read ..... Min (-15) .... Max (-14.999)

Now....change the lower set to read ..... Min (-0.001) ... Max (0.001)

NOTE: Stock values are -35/20 for the upper set and -90/90 for the lower set, just in case you wish to change back.

------------------------------------------------------------------------

Using these modified values, (which were used to tweek Anvart's Camera mod ) the camera will open on the PPI radar screen in a fixed position and will not move.

You can , of course make adjustments to those values if needed, depending on the screen resolution used, ( this was sucessfully tested at 1280X960)

NOTE: Dont forget to remove the COPY of the Camera_dat from the library file before viewing.

06-17-07, 12:26 PM	#5
Canonicus XO Join Date: Mar 2007 Location: In your baffles... Posts: 434 Downloads: 624 Uploads: 7	Thanks for the nice words, Mraah..... I try to help, if I can. As far as making the camera fixed on the radar screen and not move.... Here's the particulars for that mod.... ------------------------------------------------------------------------ Open Camera_dat via MiniTweeker and go to RadioRoom_Radar_Ascope Look for AxisRotation Angles Min / Max You'll see TWO sets... The upper set are the values controlling range, in degrees, for vertical motion. The lower set are the values controlling range, in degrees, for horizontal motion. We're going to adjust those values. Change the upper set to read ..... Min (-15) .... Max (-14.999) Now....change the lower set to read ..... Min (-0.001) ... Max (0.001) NOTE: Stock values are -35/20 for the upper set and -90/90 for the lower set, just in case you wish to change back. ------------------------------------------------------------------------ Using these modified values, (which were used to tweek Anvart's Camera mod ) the camera will open on the PPI radar screen in a fixed position and will not move. You can , of course make adjustments to those values if needed, depending on the screen resolution used, ( this was sucessfully tested at 1280X960) NOTE: Dont forget to remove the COPY of the Camera_dat from the library file before viewing. Last edited by Canonicus; 06-17-07 at 08:12 PM.