SUBSIM Radio Room Forums - View Single Post

Drag0n · 05-21-07, 03:45 PM

It's me again with one more question. I had some experience with the seawolf sonar from Sub Command, but today when I tried my hadn with the Seawolf, I found a few thing out of place.
1. Under no circumstance was I able to assign a tracker in the narrowband display(pressing the corresponding button does nothing). I can assign them all right in broadband, but as far as narrowband is concerned, trackers don't seem to exist.
2. When I place the cursor above a signal in either the broadband or the narrowband waterfall, it shoud show info about that particular signal(the tracker assigned to it,or none if none is assigned). Well, instead all i get is the last used tracker. This makes identifying a target extremely hard,as it takes quite some time to realise which contact I am analyzing.
So,anyone encountered this before?

05-21-07, 03:45 PM	#1
Drag0n Swabbie Join Date: May 2007 Posts: 7 Downloads: 0 Uploads: 0	Sonar working...weird It's me again with one more question. I had some experience with the seawolf sonar from Sub Command, but today when I tried my hadn with the Seawolf, I found a few thing out of place. 1. Under no circumstance was I able to assign a tracker in the narrowband display(pressing the corresponding button does nothing). I can assign them all right in broadband, but as far as narrowband is concerned, trackers don't seem to exist. 2. When I place the cursor above a signal in either the broadband or the narrowband waterfall, it shoud show info about that particular signal(the tracker assigned to it,or none if none is assigned). Well, instead all i get is the last used tracker. This makes identifying a target extremely hard,as it takes quite some time to realise which contact I am analyzing. So,anyone encountered this before?