SUBSIM Radio Room Forums - View Single Post

panthercules · 04-30-07, 07:39 PM

Thanks for the reply - I did try reading that tutorial before, and it was basically "whoa - this is waaaay over my head complicated!"

However, I think you confirmed my fears from looking at this myself after I posted my questions last night. When you say:

"Finally, adjust for the position of each object... "

do I interpret that correctly that there's not any one place I could make this change but I'd basically have to make the same change to every element or section of the [G25 Ixx] part of the .ini file (i.e., [G25 I1] to [G25 I47]) so all aspects of the manual would move up together on the screen? I guess since the horizontal pixel location could stay the same, I'd only have to change the "y" number in the "zone" line in all those sections by the same amount (for example, increase each Y number by 400 or some such number) to move it upwards on the screen?

That doesn't sound too bad - quess I'll give it a shot and see what happens (that's what backups are for, right?)

Thanks for the tips

[edit] AWESOME - it turned out to way simpler than all that - I just changed the one "Y" number in the "Zone" line in the very first section ([G25 I1]), and it worked like a charm - I tried changing the "0" to "400" and the manual is right up near where I want it - I will probably make it 450 or 500 to get it a little higher, but that one change was all it took. Woohoo! Thanks for the clue that made it so easy

04-30-07, 07:39 PM	#15
panthercules The Old Man Join Date: Apr 2005 Posts: 1,336 Downloads: 6 Uploads: 0	Thanks for the reply - I did try reading that tutorial before, and it was basically "whoa - this is waaaay over my head complicated!" However, I think you confirmed my fears from looking at this myself after I posted my questions last night. When you say: "Finally, adjust for the position of each object... " do I interpret that correctly that there's not any one place I could make this change but I'd basically have to make the same change to every element or section of the [G25 Ixx] part of the .ini file (i.e., [G25 I1] to [G25 I47]) so all aspects of the manual would move up together on the screen? I guess since the horizontal pixel location could stay the same, I'd only have to change the "y" number in the "zone" line in all those sections by the same amount (for example, increase each Y number by 400 or some such number) to move it upwards on the screen? That doesn't sound too bad - quess I'll give it a shot and see what happens (that's what backups are for, right?) Thanks for the tips [edit] AWESOME - it turned out to way simpler than all that - I just changed the one "Y" number in the "Zone" line in the very first section ([G25 I1]), and it worked like a charm - I tried changing the "0" to "400" and the manual is right up near where I want it - I will probably make it 450 or 500 to get it a little higher, but that one change was all it took. Woohoo! Thanks for the clue that made it so easy __________________ Last edited by panthercules; 04-30-07 at 08:19 PM.