Ok... i dont want to claim victory yet, but i think so i discovered the @#$$ problem.
1]
In SH III the sensor anglas was taked :
Zero degree UP
180 degree Down.
2]
MaxHeight and MinHeight goes from up to down, but it is from zero to 180, vertical axis.
3]
But in SH IV SD radar it seem to be :
Zero degree nose
180 degree back
zero to 180 is not the vertical axis here, is the horizontal axis.
4]
Then, if maxHeight and MinHeight goes from zero to 180 axis, it means this value is gong from nose to back....
It is the horizontal axis !
5]
When we adjust MinHeight and MaxHeight, really we are adjusting MaxRange and MinRange... into the horizontal axis !
No... no... i not become crazy... :rotfl:
just adjust into file V1.2, in wich one we lost all radar contacts :
MaxHeight=25000
MinHeight=-25000
and you recover the contacts....
Then.....
If this is true.... im not sure yet.
MaxRange and MinRange works as MaxHeight and MinHeight ????
SD still picking up ship contacts, but i think so it is due the settings , may be all settings are rotated 90 degrees.
When we adjust a value thinkig we do it into the vertical axis, really we are adjusting a value into the longitudinal axis !!!
Please it is abit confuse, good is some body can test.
Not sure if this is the problem, but i recover the contacts and it is the only logical explanation i can reach for this behaviour.
.