Quote:
|
Originally Posted by CableRouter
There is a simpler method. Do everything normally, lock on, enter AoB and speed, then enter range. Then just before you fire, unlock the scope with the L key, aim the scope at the part of the ship you want to target, then hit the transmit data button. The TDC will update the solution for the new bearing. It's a lot easier than going to the torpedo data screen and trying to input an offset manually and it shouldn't take more than a 2-3 extra seconds.
|
Two pages until someone finally brings it up. I've written about that in the past already several times, but nobody seems to read or understand it. Thank you, CableRouter.
Well, in the end, had the devs included a simple MARK button for bearing transmission like there was iRL, there would be
-more realism
-less confusion
-easier operation
The MARK button was such in integral part of the TDC that I do not understand why they didn't incooperate it and instead used "indirect" bearing transmission.
Read any book. "This is a firing observation! Stand by forward! Range 1200 yards. Bearing - MARK! Fire One!..Fire Two!...Fire Three!" "Three torpedoes fired electrically."