Quote:
|
Originally Posted by DivingDuck
Moin,
here it is:
Open the Turm.cam you want to edit with any hex editor and change the highlighted values. - x moves left - right
- y moves up - down
- z moves forward - aft
The values have to be in float(32) format.
Regards,
DD |
Hello Diving Duck,
thank you for sharing your knowledge. But I think the position in the cam file is wrong. If I change the values starting from 168 (Hex position) it works!
So, in my opinion x values start at 168, y values start at 16C and z values at 170
But thank you anyway
, because if you did not point us to the correct file and the approximate position I would never have found it.
Regards
Mr. Fleck