That is what I need , well apart from a new PC.
my fr is all over the place, as a test I go into Sub School Nav. I'll get the fr jumping in the CR room once its settled somewhere between 25/30+, nav map 35/40 and on the Bridge 20/25. Then in the same map when the same conditions, I will get 20 CT , 30 nav map and 15/19 on the Bridge. And again, same setting, I will get the Bridge down to 4/5.
Its doing my nut in ... When I was getting the CR at 25/30+ and nav map 35/40 and the Bridge 20/25. I would pause the game and go to the graphic setting, the setting I had for the 25/30+ - 35/40 - 20/25 I had all but 2 sliders to the far right, the 2 above gamma I had set in the middle, and I had all the boxes on the right ticked the ones on the left next to the sliders I left alone.
Yet with these same settings I could tick all the boxes left too just to see what it looked like, and doing so did hit the fr that much by 4/5 frames in each place CR NM and Brd.
I would untick all the boxes on the left again and I would get back these frames. then for no reason still dead in the water, and in the CR the frames would drop and when on the bridge they would be down in single figures low single figures.
I just don't get it , they would jump back again later to a higher fr?
But I will invest in another 1Gb of ram, what kind of fr jump did you get adding the extra Gb?
|