Bring up your Ship Registry and look for your contact. Once found, make sure to check the box so the mast height is entered on the notepad as in the picture below. OK THIS IS WHAT AM TAKING ABOUT,WHEN I TRY TO DO THIS IM NOT GETTING MAST HEIGHT IN THE UPPER RIGHT CORNER WHERE IT SHOULD BE AS ILLUSTRADED IN THE FOTO YOU SEE THAT IT SHOWS THE MAST HEIGHT,WELL I DONT HAVE THAT,WHEN I CLICK ON THE LITTLE BOX IN THE RECONITION MANUAL. Get Range to Target Place the horizontal line of your scope on the waterline of the target. Next, click on “Range” in the Notepad. This will switch you to the Stadimeter which you then place at the top of the highest mast of the ship. Click the left mouse button when the line has been placed on the highest mast. The range to target will then appear in the Notepad. HERE IN THE TEXT IT SAYS CLICK ON RANGE IN THE NOTEPAD,WELL I DONT HAVE THAT SHOWING? Get Range to Target Place the horizontal line of your scope on the waterline of the target. Next, click on “Range” in the Notepad. This will switch you to the Stadimeter which you then place at the top of the highest mast of the ship. Click the left mouse button when the line has been placed on the highest mast. The range to target will then appear in the Notepad.
Place the horizontal line of your scope on the waterline of the target. Next, click on “Range” in the Notepad. This will switch you to the Stadimeter which you then place at the top of the highest mast of the ship. Click the left mouse button when the line has been placed on the highest mast. The range to target will then appear in the Notepad.
03-07-07, 12:41 AM
