View Single Post
Old 01-06-07, 02:10 PM   #2
Samwolf
Seasoned Skipper
 
Join Date: Jan 2006
Location: South Carolina, CSA
Posts: 684
Downloads: 37
Uploads: 0
Default

Quote:
Originally Posted by Lanzfeld
I dont go over 16X when on patrol so it is obvious that I save alot during the same patrol because I take so long. When I want to play again I always start SH-3 Commander and "Launch" SH-3 through Commander. Is this the correct way to do it? If I had a random failure in my last game would launching again through Commander reset the malfunction? Should I only start the game through Commander when I am in port and going to start a new patrol?

You see my question is do I "reroll the dice" on malfunctions and sabatage EVERYTIME I start the game through Commander even when at sea or does it only "roll the dice" at the start of a patrol?
Some of the malfucntions will only occur when starting a patrol, others are a "roll of the die" on each load through Sh3Commander. I'm pretty sure that the following can only occur at the beginning of a patrol:

Periscope Malfunction
Snorkel raise/lower time Malfunction
Radar/Sonar Range Malfunction
Flak Gun Reload time Malfunction
__________________


GWX 3, JSGME 2.3, Sh3 Commander 3.2 SH3 Gen 8.1, Water Stream for U-boats, LRT LITE 2.0, Lifeboats for SH3

Samwolf is offline   Reply With Quote