Question: Is it possible to extract the 3D model of a harbour using Pack3D, retrieve the sub pens, and then make them a separate model to be placed in-game, as an environmental folder Land unit or locations.cfg entry? I want to make a "harbour" for the u-boats out of Laksevåg consisting of only the sub pens.
Quote:
|
If you wish, i could make the repaint of DD's cutter without the numbers on. This way i dont have to worry about that mirroring issue.
|
Feel free.
Quote:
|
this one is a very good site about the norwegian merchant fleet or ... home fleet and has the list of all ships in axis service in alied service from norway i really advice this one
|
Thanks a lot, but it's already been presented to me
.
Quote:
|
I have to say though that many ships in Bergen may well cause a massive FPS hit
|
It does, so I'm planning to release a "Light" version or two. Either two versions - one with far fewer ships and one with no ships, or simply one version, with no ships, the way
GWX did it.
Quote:
|
Also with the unfortunate drift issue of SH3 and docked ships if you sail back into port you may well find a lot of them on top of each other
|
I didn't know about that. I'll have to do some testing and see what happens. Hmmm... maybe I could have a massive minefield outside the harbour. That'd discourage the player from returning there after a finished patrol:p.
Quote:
|
Looking good though I must say
|
It had better, with all my effort:p.