[Seadawg23]

Sea Queen....what was the SEA STATE??? I presume 4....I did not know you were attacking a Kirov.....it draws 16-18 feet... SO!!! if sea state 5....15 will work depending on a few things, the range...as per your post 5500 M...maybe NO dice i would think: u got lucky@@@

look at it this WAY:
Sea State 1: FLAT you can set torp to 5 if u want...all good!!
ST(for now on sea state): 2: Alittle ruff....waves 2 ft approx: Default 10 feet good

ST2: see above...NO concern waves about 3 feet or 1 meter

ST3: if....i have seen... Torps bounce with default settings....Only if!!! pay attention!!....you are shooting perpendicular or 45 degs give or take 10 deg on the WAVE trough!!
RARELY....will you see a true perpendicular shot...up to 10 DEG either side depending on depth!!! CAN cause torp jumping!! OFF TOPIC!!! a SUB launched TORP will HOLD the DEPTH of FIRING sub...UNTIL enable is ACTIVE..... SO VERY IMPORTANT!!!!!


A SUB at 1200 fl....launches a ADCAP:: look out!!!

Range to Enable: 10000 yrds(((( DEFAULT)))..USE,,,NAVMAP.RANGE CIRCLE..HYPOTHAEICAL(SPELLING)to ====
Ceiling: DEFAULT: 10 FT...TIS CRAP!!!! SET TO 20 FT!! why??? periscope depth is 53 ft...688(i) USN...you kill all subs...they within min/max SET ALWAYS...set enable TO MIN OF 2 nm(or 4000 yrds) srry yell...typo!!!

Range to Enable: 10,000 yrds( can adjust= TMA for new solution) use NAVMAP...to see...UPDATES!!.!( = 10 NM default)
Set Ceiling: 20 FT( AI....at 10 feet)
20 ft should hit ALL SURFACE minus fishing boats ...CIVILIAN Cruise liners and UP...YES...a civilian tanker/cruise...draws 16 ft water U WILL miss on torp shot!!!
Set MAX depth...vs: AI to 200 ft....rare for them to dive DEEP. on 1st torp....set next to default MAX depth... WHY? launch 2 torps 1 will miss..

LALALA...i can g oon and on...replies!!






that is all....look for more after