SUBSIM Radio Room Forums - View Single Post

VoodooPriest · 08-17-06, 03:31 PM

Can I ask a question about problems with SH3 Commander in here? Yes? Good, as I have one.

The problem is as follows:
Suddenly SH3-Comander won't load SH3 anymore. The reason is, that it can't write into the NSS_Uboat7c.cfg and ends the launch-prrocess with an according error-message. When I look into the file's properties it says "read only". I then uncheck this option and try to launch SH3 again and again the error occures because the "read only"-status has mysteriousely returned... I tried several combinations of unchecking and restarting/rebooting but nothing worked so far. As I said, the error suddenly appeared out of nowhere.

So, what can I do?

08-17-06, 03:31 PM	#11
VoodooPriest Mate Join Date: Aug 2005 Posts: 52 Downloads: 21 Uploads: 0	Can I ask a question about problems with SH3 Commander in here? Yes? Good, as I have one. The problem is as follows: Suddenly SH3-Comander won't load SH3 anymore. The reason is, that it can't write into the NSS_Uboat7c.cfg and ends the launch-prrocess with an according error-message. When I look into the file's properties it says "read only". I then uncheck this option and try to launch SH3 again and again the error occures because the "read only"-status has mysteriousely returned... I tried several combinations of unchecking and restarting/rebooting but nothing worked so far. As I said, the error suddenly appeared out of nowhere. So, what can I do? Last edited by VoodooPriest; 08-17-06 at 03:34 PM.