SUBSIM Radio Room Forums - View Single Post - 88mm deck gun mod for the Type II (almost there)

mikolajcap21 · 12-19-24, 11:55 PM

I tried what you posted on my previous post and had no luck with it.

I completely forgot about the AnimationObject!

I found my problem I had two nodes that were named <20mmTwin_UFlak_High_Body>Single and the one that was the parent chunk did not have the model so moving the node around did nothing.

I then went to the AnimationObject that controls the 20mm single and went to the KeyFrame that controls the AnimName that the barrel assembly is assigned to. I adjusted the FollowPath values and tweaked the values to move the assembly into place.

All that's left to do is to sort out the crew node, wheel crank animation, and simulation settings.

Thank You!

12-19-24, 11:55 PM	#3
mikolajcap21 Swabbie Join Date: Nov 2019 Posts: 12 Downloads: 7 Uploads: 0	I tried what you posted on my previous post and had no luck with it. I completely forgot about the AnimationObject! I found my problem I had two nodes that were named <20mmTwin_UFlak_High_Body>Single and the one that was the parent chunk did not have the model so moving the node around did nothing. I then went to the AnimationObject that controls the 20mm single and went to the KeyFrame that controls the AnimName that the barrel assembly is assigned to. I adjusted the FollowPath values and tweaked the values to move the assembly into place. All that's left to do is to sort out the crew node, wheel crank animation, and simulation settings. Thank You!