SUBSIM Radio Room Forums - View Single Post - OT: Help needed,my system becomes unstable

porphy · 07-08-06, 06:36 AM

Hi Sky

I'm no expert in these matters, but don't you think it sounds as if when you cold start the comp, your PSU is not up to it. When the components in it get warm, it stabilizes and runs fine and therefore cope with full load use. This also fits with the behaviour that it restarts just fine after some use.
HDD failures usally go with clicking sound and the drives spinning, but you don't seem to get that and the HDD should show problems when working, not only at boot I guess. I still think your PSU is dying, but perhaps a slow death. Not a heartattack like mine.

But it's hard to know for sure without changing parts around, it sounds as if you will have solved the puzzle soon though.
You could take the PSU to the shop and let them measure the output. I did that to be sure it was the psu that had gone out. Connecting a new PSU is'nt that hard as long you have documentation on your motherboard layout. From this you can figure it out, no doubt. Just check if the connector to motherboard is ATX 2.0, most PSU have a adapter if you run a older motherboard. The ppl in the shop should sort that out for you.

07-08-06, 06:36 AM	#15
porphy Commodore Join Date: Nov 2002 Location: Sweden Posts: 603 Downloads: 4 Uploads: 0	Hi Sky I'm no expert in these matters, but don't you think it sounds as if when you cold start the comp, your PSU is not up to it. When the components in it get warm, it stabilizes and runs fine and therefore cope with full load use. This also fits with the behaviour that it restarts just fine after some use. HDD failures usally go with clicking sound and the drives spinning, but you don't seem to get that and the HDD should show problems when working, not only at boot I guess. I still think your PSU is dying, but perhaps a slow death. Not a heartattack like mine. But it's hard to know for sure without changing parts around, it sounds as if you will have solved the puzzle soon though. You could take the PSU to the shop and let them measure the output. I did that to be sure it was the psu that had gone out. Connecting a new PSU is'nt that hard as long you have documentation on your motherboard layout. From this you can figure it out, no doubt. Just check if the connector to motherboard is ATX 2.0, most PSU have a adapter if you run a older motherboard. The ppl in the shop should sort that out for you. __________________ "The only remedy for madness is the innocence of facts." O. Mirbeu "A paranoid is simply someone in possession of all the facts." W. B.