SUBSIM Radio Room Forums - View Single Post - [REL] DGUI 1920x1080 for GWX and Stock SH3

diego_gut · 07-31-21, 12:50 PM

I tried to keep it as historically correct as possible but SH3 simply does not have all the original instruments. Also, the original TDC did not have torpedo settings.

The following dials are in their correct positions: target speed, target range, angle on bow, spread angle, gyroangle, and target bearing. I used the rest of the positions to place the other dials and switches on SH3s' TDC.

The dial in the upper left corner is a special case. As derstosstrupp explained, the dial that looked like that was the torpedo impact angle. That dial does not exist in SH3 and it is there for decoration. However, it is used for the 2nd gyroangle setting for Fat/Lut torpedoes and I use it for that. So, when you select a Fat/Lut torpedo it becomes active and gets a label.

Regards

07-31-21, 12:50 PM	#174
diego_gut Soundman Join Date: Aug 2020 Location: Costa Rica Posts: 147 Downloads: 25 Uploads: 0	I tried to keep it as historically correct as possible but SH3 simply does not have all the original instruments. Also, the original TDC did not have torpedo settings. The following dials are in their correct positions: target speed, target range, angle on bow, spread angle, gyroangle, and target bearing. I used the rest of the positions to place the other dials and switches on SH3s' TDC. The dial in the upper left corner is a special case. As derstosstrupp explained, the dial that looked like that was the torpedo impact angle. That dial does not exist in SH3 and it is there for decoration. However, it is used for the 2nd gyroangle setting for Fat/Lut torpedoes and I use it for that. So, when you select a Fat/Lut torpedo it becomes active and gets a label. Regards