I still cannot get the TDC Salvo/Single switch markings to work...they only work on the Attack Map. I see the included files in an "SH3Commander" folder (which I assume ARB installed as I have not installed SH3Commander) but what do I do with them to make the tube markings appear?
Never mind...figured it out...finally.
Never mind the "never mind"...the "fix" provided is worse than the problem! The "fix" provided in the ARB mod uses SH3 Commander to add the tube numbers to the selector dial.
1. Why can't the issue be fixed
without SH3 Commander? (I don't care as I use it...but others may not?).
2. The "fix" is wrong, anyway...the tube numbers are incorrect for the uboat you are in. I'm in a type IX...and this is what I see after the "fix":
Completely wrong for a Type IX...and the "T" or "S" switch changes nothing.
This is what it looks looks like without the fix...no tube numbers:
And this is what it should look like for a Type IX, in "Single" mode...
and now, Salvo mode...
Not quite sure how to fix this myself, so I'll just wait and see if someone smart can figure it out.