SUBSIM Radio Room Forums - View Single Post

LuftWolf · 06-19-06, 08:58 PM

Put the bearing cursor on the spike. Then click on a frequency line, THEN hit Mark.

In the narrowband, you are marking an individual frequency along a particular bearing rather than the whole contact.

06-19-06, 08:58 PM	#6
LuftWolf Ocean Warrior Join Date: May 2005 Location: Free New York Posts: 3,167 Downloads: 2 Uploads: 0	Put the bearing cursor on the spike. Then click on a frequency line, THEN hit Mark. In the narrowband, you are marking an individual frequency along a particular bearing rather than the whole contact. __________________ LW